Booster · Service Manual
Booster T1 / K1 Service Manual
The closest thing to a Booster T1 / K1 service manual is Booster's official support portal, linked below. It hosts the manufacturer's own repair and setup resources — the only service information we consider trustworthy enough to link.
Service work on a humanoid is genuinely different from consumer electronics: joints are preloaded, wiring runs through rotating assemblies, and most actuator replacements require recalibration afterward. If a procedure isn't in the official portal, treat third-party teardowns as entertainment, not instructions.
What this document covers
- ✓Exploded diagrams with official part numbers for ordering spares
- ✓Step-by-step disassembly and reassembly sequences
- ✓Actuator and joint-module replacement procedures
- ✓Fastener torque specifications and thread-locker guidance
- ✓Joint calibration and zero-position routines after repair
- ✓Diagnostic modes and factory reset procedures
Official service manual
What we know about the Booster T1 / K1
For part numbers and ordering, see our parts directory at HumanoidSpareParts — and for anything beyond a simple swap, a vetted technician (HumanoidTechnicians) is cheaper than a second repair.
Booster's official documentation is thinner than Unitree's — start with the support portal for repair and setup resources. Third-party 'T1 manual' PDFs circulate on mirror sites, but we only link official sources, so verify anything you download elsewhere against the support portal.
Booster T1 / K1 at a glance
- Type
- Research humanoid
- Use
- Research, education, RoboCup