Booster · Error Codes
Booster T1 / K1 Error Codes
No public error-code reference has been published for the Booster T1 / K1. Booster hasn't released fault tables, diagnostic-code lists, or troubleshooting flowcharts — so there's no official document to link to, and we won't invent codes.
What we can tell you from owner experience: most humanoid faults cluster in a few families — joint torque faults under load, battery/charging faults, IMU and sensor errors, and communication dropouts between joint controllers. The setup notes below describe the failure modes actually reported for this model.
What this document covers
- ✓Fault-code tables with causes and recommended actions
- ✓LED and status-indicator patterns during boot and faults
- ✓Joint torque faults: distinguishing calibration drift from hardware failure
- ✓Battery, charging, and power-distribution fault behavior
- ✓IMU, encoder, and sensor error handling
- ✓Safe recovery: reboot sequences, factory reset, and when to stop and call support
Official error codes & troubleshooting guide
No public error codes & troubleshooting guide has been published for the Booster T1 / K1.
We link only to official manufacturer sources — never rehosted PDFs or third-party mirrors — so when the manufacturer hasn't published a document, this page says so plainly instead of linking something unreliable. The closest authoritative source is Booster Robotics official site.
What we know about the Booster T1 / K1
Booster's official documentation is thinner than Unitree's — start with the support portal for repair and setup resources. Third-party 'T1 manual' PDFs circulate on mirror sites, but we only link official sources, so verify anything you download elsewhere against the support portal.
Request this manual and we'll expand coverage as Booster publishes more.
Booster T1 / K1 at a glance
- Type
- Research humanoid
- Use
- Research, education, RoboCup