EngineAI · Service Manual
EngineAI PM01 Service Manual
No public service manual has been published for the EngineAI PM01. Manufacturers in this space treat service documentation as proprietary — repairs go through their own channels or authorized partners, and exploded diagrams with part numbers simply aren't public.
A real EngineAI PM01 service manual would include disassembly sequences, actuator replacement procedures, torque specifications, and the joint-calibration routines that must run after any repair. Until one exists, don't attempt internal repairs based on forum teardowns: mis-torqued joints and uncalibrated actuators are how repairable robots become parts donors.
What this document covers
- ✓Exploded diagrams with official part numbers for ordering spares
- ✓Step-by-step disassembly and reassembly sequences
- ✓Actuator and joint-module replacement procedures
- ✓Fastener torque specifications and thread-locker guidance
- ✓Joint calibration and zero-position routines after repair
- ✓Diagnostic modes and factory reset procedures
Official service manual
No public service manual has been published for the EngineAI PM01.
We link only to official manufacturer sources — never rehosted PDFs or third-party mirrors — so when the manufacturer hasn't published a document, this page says so plainly instead of linking something unreliable. The closest authoritative source is EngineAI official site (Chinese).
What we know about the EngineAI PM01
For part numbers and ordering, see our parts directory at HumanoidSpareParts — and for anything beyond a simple swap, a vetted technician (HumanoidTechnicians) is cheaper than a second repair.
EngineAI's official site is Chinese-language, which is where PM01 specs and updates live. No English user manual has been published — browser translation of the official site is currently the most practical route for non-Chinese speakers.
EngineAI PM01 at a glance
- Height
- 1.38 m
- Degrees of freedom
- 24
- Top speed
- 2 m/s